Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Trusted Duct Repair & Sealing for Upper West Side Homeowners
Leaky ductwork is easy to miss because it hides above ceilings, behind walls, and inside closets. What you notice instead is the symptom: a bedroom that never gets warm, dust that settles back a day after cleaning, or a musty smell every time the heat kicks on. Duct repair and sealing finds the actual gaps, disconnected joints, and torn flex runs, then closes them so conditioned air reaches the rooms you’re paying to heat. Our technicians have up to 9 years of experience, and we use Rotobrush contact-cleaning systems and Nikro commercial vacuums, so we’re not guessing with a shop vac and a flashlight. We answer 24/7 with fast dispatch from 7am to 7pm, Sunday through Friday, and same-day visits are often possible. Call (855) 552-7560.
What Our Duct Repair & Sealing Service Includes
Most Upper West Side buildings have duct systems that were installed decades ago and altered several times since. Prewar co-ops on Riverside Drive and West End Avenue often have metal trunk lines running through soffits and crawl spaces, while newer conversions lean on flex duct routed through tight chases. Each material fails differently, and each repair job starts with identifying which one you have before touching a joint.
Duct Sealing
Duct sealing closes the gaps at joints, seams, takeoffs, and register boots so air travels where it’s meant to. You need it when rooms run hot and cold unevenly, when the furnace cycles longer than it should, or when your energy bills creep up without a change in habits. We seal with mastic and mesh at accessible joints, then verify airflow at the registers before and after, so you can see the difference in the rooms that were struggling.

Flex Duct Repair
Flex duct is the silver corrugated run you’ll find in ceiling chases and between floors. It kinks, sags, and tears at the collars, and a crushed section can cut airflow to a room by half. We replace damaged sections with properly supported, correctly sized flex and reconnect the collars so the run stays round instead of pinched.

Metal Duct Repair
Sheet metal duct separates at the seams, rusts through at the bottom of trunks, and loses screws at the takeoffs. When a joined section has pulled apart inside a soffit, you get a steady stream of warm air into the wall cavity instead of the bedroom. We reseal seams, reattach loose sections, and patch or replace rusted-through areas with metal and mastic so the trunk holds pressure again.

Duct Insulation
Uninsulated duct running through a cold crawl space or an attic loses heat before it ever reaches the room. You need insulation when the ducts themselves are fine but the air arrives lukewarm, or when you see condensation on metal runs in humid months. We wrap accessible runs with duct insulation and seal the vapor barrier so you’re not trading heat loss for moisture problems.
Mastic Sealant
Mastic is the brush-on sealant that actually holds up on ductwork, unlike tape that dries, cracks, and peels within a season. We use it on every accessible joint, seam, and boot we seal, because it bonds to metal and stays flexible through heating and cooling cycles. If a previous repair was done with cloth tape, that’s often the first thing we find failing.
Air Leak Repair
Air leak repair is the hunt for the places ductwork loses pressure: disconnected collars, gaps around register boxes, and unsealed penetrations where ducts pass through walls. You need it when you can feel air moving in a closet or basement where no register exists, which means conditioned air is escaping into the building instead of the room. We trace those leaks with airflow readings and seal them at the source.
Styles & brands we work with
- Whole-home duct cleaning
- Dryer vent cleaning
- Camera inspection
- Sanitizing & deodorizing
Brands We Service for Duct Repair & Sealing
Duct repair work often intersects with whole-home air quality equipment a building already has. We work with Honeywell and Aprilaire systems and know how their controls and components interact with the duct pathway, so sealing a run doesn’t create a pressure problem elsewhere in the system. When a job involves sanitizing after a repair, we use Abatement Technologies air scrubbers and negative-air equipment, the same class of filtration used in mold and disaster remediation, alongside Guardsman-grade protective treatments.
We also service ductwork connected to Rotobrush and Nikro cleaning systems that other contractors have worked on previously, and we can tell from the joints and sealant work whether the earlier job was thorough or surface-level. Whether you have Honeywell, Aprilaire, or any other make of air quality equipment tied into your ductwork, we can help.
Signs You Need Duct Repair & Sealing Right Now
- Rooms that never match the thermostat. If the bedroom at the back of the apartment stays cold while the living room overheats, that’s usually a duct losing air before it arrives. Sealing the leak fixes the imbalance at the source rather than masking it.
- Dust that returns within a day. Dust settling back onto furniture right after cleaning often means unfiltered air is pulling in through gaps in return ducts. Sealing stops that path.
- A musty or dusty smell when the system runs. Odor that appears only when the heat or AC turns on points to air moving through a gap in a wall cavity or crawl space. That’s a repair issue, not a cleaning one.
- Visible tears, sagging, or disconnected flex duct. If you can see a crushed or separated run in an accessible area, it’s already costing you airflow. Flex that’s torn or kinked should be repaired before it collapses further.
- Rising energy bills with no change in use. A duct system losing a noticeable share of its air makes the equipment work harder for the same comfort. Sealing typically pays back through lower run time.
Our Duct Repair & Sealing Process – Step by Step
- 1
Inspection and airflow readings. We start by measuring airflow at the registers and inspecting accessible ductwork for disconnected joints, crushed flex, and unsealed penetrations. That baseline tells us where the losses actually are, not where they usually are.
- 2
Cleaning before repair. Sealing over dirty ductwork traps debris inside. We run Rotobrush contact cleaning and Nikro vacuum extraction first, so the surface we seal is clean and the repair holds.
- 3
Repair and material matching. Flex runs get replaced, metal seams get reattached, and rusted sections get patched with the right material for that duct type. We don’t seal a metal trunk the same way we seal a flex collar.
- 4
Sealing at every accessible joint. Mastic and mesh go on the joints, seams, and boots we can reach, with proper curing time so the sealant bonds instead of peeling. Register boots and penetrations get sealed too.
- 5
Verification and photos. We re-measure airflow at the same registers for a before-and-after comparison and show you photos of the work. If a section couldn’t be accessed, we tell you plainly rather than claiming it was sealed.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Duct Repair & Sealing Cost in Upper West Side?
Duct repair and sealing in Upper West Side typically runs $350 to $1,200 for a single-zone apartment system, depending on how much ductwork needs work and how accessible it is. A straightforward repair of one or two disconnected flex runs and sealing accessible joints usually lands at the lower end. A full trunk-line reseal in an older prewar building with ducts buried in soffits and wall chases runs higher, because access drives the labor more than materials do.
What moves the price: the number of separate duct runs involved, whether the ducts are metal or flex, how much of the system is reachable without opening walls, and whether cleaning is needed first. Buildings with multiple zones or a rooftop unit serving several apartments scale accordingly.
We set one flat price per system, agreed before any work starts, and the written estimate is the final number. No per-vent pricing, no surprises once we’re on site. The estimate includes the inspection, airflow readings, and a clear scope of what will be repaired versus what’s inaccessible.
To keep from overpaying, ask any contractor whether their quote covers cleaning before sealing, whether they verify airflow afterward, and whether they’ll show you photos. A quote that skips any of those is usually a sealant spray over dust that won’t last a season. Call (855) 552-7560 for an exact quote; estimates are free.
Duct Repair & Sealing Near Upper West Side – Our Service Area
We cover duct repair & sealing across Upper West Side and the surrounding neighborhoods, including Morningside Heights, Hell’s Kitchen, the Upper East Side, East Harlem, and Roosevelt Island, with fast dispatch from 7am to 7pm, Sunday through Friday. Buildings closer to the core of the Upper West Side are typically reached same day when you call in the morning.
If you’re outside that radius, our air duct cleaning Upper West Side page covers the parent service, and nearby neighborhoods have their own pages for duct repair & sealing in Melrose and duct repair & sealing in Morrisania. For the full repair scope in this neighborhood, see our duct repair & sealing page.
Serving Upper West Side, NY – Our Local Coverage Area
We serve Upper West Side and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Duct Repair & Sealing in Upper West Side
Duct repair and sealing is the process of fixing damaged or disconnected ductwork and closing the gaps where conditioned air escapes. It addresses torn flex runs, separated metal seams, and unsealed joints rather than just cleaning what’s there. In Upper West Side buildings, it often means resealing decades-old metal trunk lines and replacing crushed flex in tight chases. The goal is getting the air you’re paying for into the rooms.
Most single-apartment duct repair jobs in Upper West Side take three to six hours, including cleaning, repair, sealing, and airflow verification. Larger systems with multiple zones or heavy access work can run a full day. We give you a realistic time window with the written estimate so you can plan around it.
Typical duct repair and sealing in Upper West Side runs $350 to $1,200 depending on the number of runs, duct material, and access. Limited single-run repairs sit at the low end; full trunk reseals in older buildings run higher. Call (855) 552-7560 for an exact quote; estimates are free.
Yes. We work with Honeywell and Aprilaire air quality systems and know how their components interact with the duct pathway, so a repair doesn’t upset the balance of the whole system. We also service ductwork connected to Rotobrush and Nikro cleaning systems from previous work. Whether you have Honeywell, Aprilaire, or any other make, we can help.
Same-day service is often available when you call in the morning. We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm. Saturday is closed.
We stand behind the repair work we perform and will discuss the specifics with you at the time of the estimate. Because duct failures often depend on the surrounding building, we’re upfront about what’s covered and what isn’t. If something we sealed fails, call us and we’ll address it.
Clear access to the registers, thermostat, and any closets or utility areas where ductwork runs. If you have pets, secure them during the visit, since we use negative-air equipment that pulls air through the work area. Let us know about any recent renovations or known duct issues so we can plan the inspection around them.
Schedule Your Duct Repair & Sealing Service in Upper West Side Today
If your rooms don’t match the thermostat or dust keeps coming back, duct repair and sealing in Upper West Side fixes the cause rather than the symptom. We run professional-grade equipment from Rotobrush, Nikro, and Abatement Technologies, quote one flat price per system before work begins, and show you photos of the finished job. Call (855) 552-7560 for a free, no-obligation estimate. We answer 24/7.
Written by the team at Air Duct Cleaning Upper West Side.